Washer won't drain, spin, or start? A broken washer stops the whole household. Our licensed technicians repair all major washing machine brands across San Diego — top load and front load — with upfront pricing and a workmanship guarantee.
Tell us what's wrong — we'll get right back to you.
If the form does not load, open the repair request form. Your visit is confirmed by our team.
Most washing machine faults come down to one worn part — not a machine that needs replacing.
Water sitting in the drum usually means a clogged pump filter, a blocked drain hose, or a failed drain pump.
Clothes come out soaking wet. Typically a worn drive belt, lid switch, motor coupling, or door lock on front loaders.
Often a cracked inlet hose, a worn door gasket on front loaders, or a leaking pump seal. Worth fixing fast to avoid floor damage.
Violent vibration usually points to worn suspension rods, shock absorbers, or a machine that's out of level.
No power or no response is commonly a faulty lid switch, door latch, or a failed control board.
Common on front loaders — buildup in the door gasket and detergent drawer. We clean, replace seals, and show you how to prevent it.
Front loaders and top loaders fail in different ways. Front loaders are prone to door seal leaks, bearing wear, and drain pump blockages from coins and lint. Top loaders more often see lid switch, agitator, and transmission issues.
Our technicians carry parts for both, so most repairs are finished in a single visit. You get the price before we start — if you decide not to proceed, you owe nothing beyond the diagnostic fee.
Our technicians work on all major washing machine brands, both top load and front load models.
Tell us the brand and what it's doing. We'll set a time window that works for you.
Our technician finds the real cause and gives you a firm price before starting.
Most repairs are completed in the same visit, backed by our 90-day workmanship warranty.
We come to you. Not sure if your neighborhood is covered? Give us a call — it probably is.
Nine times out of ten it's a blockage — a clogged pump filter, a kinked or blocked drain hose, or a small item like a coin or sock caught in the pump. Sometimes the drain pump itself has failed. It's usually a quick, affordable repair.
That's a spin problem. Common causes are a worn drive belt, a faulty lid switch or door lock, or a failed motor coupling. The machine fills and washes fine but never reaches spin speed.
It depends on the fault and the part needed. The standard diagnostic visit is $99.95 and is waived when the repair proceeds. You always get a firm repair price before any work begins.
If the fault is a pump, belt, switch, or seal, repair is almost always far cheaper than a new machine. After diagnosing we'll tell you honestly if a repair isn't worth it for your unit.
Yes — we service both front load and top load machines, including stacked washer/dryer units and high-efficiency models.
If the machine is leaking, shut off the water valves behind it. If it's full of water, don't force the door on a front loader — the drum may still be full.
Laundry piling up? Same-day slots available across San Diego.
iCare Appliance · Lic #A49177